Leica SE Operations Instructions download pdf (Page 24)

INSERTING/REMOVING THE BATTERY

Inserting

1. Set the main switch (1.15) to

OFF.

2. Slide the battery (C) as far as possible into the battery compartment,

contacts ﬁ rst and with the positioning groove (1.43) pointing towards the

center of the camera. It automatically engages in this position.

Removing

1. Set the main switch (1.15) to

OFF.

2. Turn the release catch (1.38) clockwise as far as it will go. A spring in the

battery compartment then pushes the battery out by around 1cm.

Note:

The locking mechanism has a catch to prevent the battery from accidentally

falling further out, even if the camera is held upright.

3. Press the battery back in by around 1mm to release the lock, and

4. then remove it from the compartment or, if the camera is held upright,

allow it to fall out.

Charge level displays (3.2)

The battery charge level is indicated in the top panel display (1.12) and - in

the picture data view (4.1) - in the monitor (1.23).

= Approx. 100%, White

= Approx. 90%, White

= Approx. 75%, White

= Approx. 50%, White

= Approx. 25%, White

= Approx. 10%, White

= Approx. 5%, Red

= Approx. 3%, Red ﬂ ashing, replacement or

recharging necessary

INSERTING AND REMOVING THE

MEMORY CARDS

The Leica S enables you to use 2 card types simultaneously to store your

picture data, and has card slots for SD/SDHC/SDXC (Secure Digital) and CF

(Compact Flash up to UDMA 7) cards.

SD/SDHC/SDXC cards have a write protection switch, that can be used to

prevent unintentional storage and deletion of pictures. This switch takes the

form of a slider on the non-beveled side of the card; in the lower position,

labeled LOCK, the data on the card is protected.

Note:

Do not touch the memory card contacts.

Inserting

1. Set the main switch (1.15) to

OFF.

2. Open the cover (1.19) on the right-hand side of the camera by sliding it

slightly backwards in the direction of the arrow and then opening it to the

right.

3. Insert the memory card(s) you want to use as follows:

a. Insert CF cards into the slot with the contacts pointing towards the

camera and the front side towards the front of the camera (1.29). Slide

it into the card slot as far as possible.

Note:

When inserting the card, make sure that the eject button (1.29a) is pushed in

completely (see "Removing" on the next page).

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 76 77

Comments to this Manuals

No comments

Leica SE Operations Instructions Page 24

Comments to this Manuals

Related products and manuals for Measuring, testing & control Leica SE