Leica R6.2 User Manual download pdf (Page 34)

When the shutter is set to any speed from

s to 1s, the symbol remains lit

constantly.

When using an SCA 351 or SCA 551 adap-

ter, leave the finger on the shutter release

after exposure to check that the flash was

adequate:

In the "X"-setting.

The symbol in the lower left of the view-

finder flashes slowly at 2 Hz (Hertz): flash

was adequate; only slight discharge of

condenser, flash immediately ready for use

again.

Fast flashing eight times a second, then

slow flashing (2 Hz): flash was adequate;

moderate discharge of condenser, flash

ready for use in 2 s. Slow flashing indicates

'flash ready'.

Fast flashing (8 Hz) for 2 s, break (no light),

then slow flashing (2 Hz): flash was ade-

quate; heavy discharge of condenser.

Resumption of flashing indicates 'flash

ready'.

No light, followed by slow flashing (2 Hz):

flash was inadequate and the condenser was

fully discharged. Resumption of flashing

indicates 'flash ready' (also see table).

Shutter-speed setting ,,B” or 1 s to

After exposure, the symbol in the view-

finder display remains lit (see table). If the

setting was too fast for flash, i.e.

125

s to

2000

s, the symbol does not light.

Caution:

The film speed set on the camera

(see page 9) also governs TTL flash-

exposure control. Settings on the flash unit

are disregarded.

Not For Resale – Free Download at http://homepage.ntlworld.com/joechan/manuals

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

No comments

Leica R6.2 User Manual Page 34