Leica Rangemaster 1600 Service Manual download pdf (Page 28)

SETTING THE UNIT OF MEASURE

The LEICA RANGEMASTER CRF 1600 can be set to

metric units or the Imperial units more commonly

used in the USA, i.e. either meters/Celsius/millibars

or yards/Fahrenheit/PSI (pounds per square inch) for

distance/temperature/atmospheric pressure respec-

tively. This setting also determines the holdover display

(in centimeters or inches) and the available ballistic

curves (see page 148).

Setting:

1. Briefly press the main button (2 / <3 s).

• The target mark appears.

2. Press and hold the secondary button (1 / ≥3 s).

•

appears below the target mark. The display

flashes to indicate that a setting can be made.

Note:

For all settings: The relevant displays disappear 3

seconds after you last press one of the two buttons.

The previously saved settings/values are retained.

3. Briefly press the secondary button twice.

•

appears below the target mark.

4. Briefly press the main button.

•

disappears, and the target mark and continue

to flash.

5. Select your preferred units of measure by (repeat-

edly) pressing the secondary button,

for Impe-

rial as used in the USA, or

for metric.

• The relevant displays continue to flash.

Note:

The current setting can always be seen in the display

– if metric values are selected, a dot appears to the

bottom right of the target mark.

6. Save your setting by briefly pressing the main button.

• The saved setting and the target mark light up

continuously for 2 seconds for confirmation and

then disappear.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 156 157

No comments

Leica Rangemaster 1600 Service Manual Page 28